There is currently a proposed revision to the ISO to remove ambiguities and to ensure an effective method of operation for changing the protocol type. An APDU is an Application Protocol Data Unit, a TPDU a Transport Protocol Data Unit. If an APDU command response pair has been defined for T=0 and it has. ISO/IEC specifies the power and signal structures, and information exchange between an integrated circuit card and an interface device such as a.
|Published (Last):||15 March 2018|
|PDF File Size:||5.75 Mb|
|ePub File Size:||5.20 Mb|
|Price:||Free* [*Free Regsitration Required]|
High level input current Iil: If there is no compatibility, the contacts shall be desactivated. Clocking or timing signal optional use by the card.
There 78166-3 clearly other possibilities and the use of these characters is still subject to agreement. They carry information relating to the available communication protocols as well as the programming voltage and current parameters for the EPROM.
The answer to reset ieo complete 12 etu after the leading edge of the last character. TC1 provides the value of N which defines the extra guard time to be used between successive characters.
The following five values are defined: The clock pulse is applied after an interval t10 from the rising edge of the reset signal. The isp will stay at this location for anyone that wants a direct link to this part of the standard.
High level input voltage Vil: Commands for card management”. This page was last edited on 19 Aprilat This part specifies the power, signal structures, and the structure for the answer to reset between an integrated circuit card s with synchronous transmission and an sio device such as a terminal.
The actual frequency, delivered by the interface device on CLK, is designated either by fi the initial frequency during the answer to reset, or by fs the subsequent frequency during subsequent transmission. The dialogue between the interface device and the the card shall be conducted through the consecutive operations:. Interface characters Optional – T1, T2, Most of ISO is important for reader manufacturers or developers who want to establish a communication with a smart card on a very low level the signal level.
If the Anwser to Reset does not begin within 40 clock cycles t3 with RST in state H t3 after T1the signal on RST shall be returned to state L at time T2 and the contacts shall be desactivated by the interface device. The electrical circuits shall not be activated until the contacts are connected to the interface device so as to avoid possible damage to any card meeting these 7861-3.
The card knows the meaning of P3 byte 5 because it is the server. The least significant 4 bits of the TO formal character give the number binary encoded of bytes in the historical field. Therefore the design of the card has to avoid inproper operation. This application contains information on cryptographic functionality.
The header has 786-3 fixed length of 32 bits and begins with two mandatory fields of 8 bits, H1 and H2. TC1 codes N over the eight bits b8 to b1. isi
ISO/IEC – Wikipedia
Interaction between the interface device and the ICC results in successive commands and responses. The duration of the ido H of the clock pulse can be any value between 10 us and 50 us ; no more than one clock pulse during reset high is allowed. When the two ends are in non-matced transmit mode, the logic state of the line may be indeterminate. The values of the codes and the corresponding protocol type are.
The interface bytes which are optional are defined in figure With the direct convention where the logic level 1 is the mark or high state then the least significant bit is transmitted first.
TB2 codes PI2 over the eight bits b8 to b1. This shows the two possibilities of the direct and inverse convention. Cards with contacts — Dimensions and location of the contacts”.
A command is always initiated by the interface device. Table 5 — Electrical characteristics of VCC under normal operation conditions.
This principle is intended to be achieved by the use of protocol type selection PTS. The numerical meaning corresponding to each information bit considered in isolation is that of the io.
These bytes are sent from the ICC to the interface device on completion of the command to indicate the current card status. The idle state shall be maintained by the interface device unless the active state is required.